EVAL-ADG2128EBZ: What type of cable can I use to connect the board to my signal generator?

Document created by analog-archivist Employee on Feb 23, 2016Last modified by analog-archivist Employee on Feb 23, 2016
Version 2Show Document
  • View in full screen mode

I want to evaluate the chip ADG2128 for my application, what type of cable can
I use to connect the board to my signal generator?

 

 

The connector used on the EVAL-ADG2128EBZ is an RCA Jack, dual type, right
angle/PCB mount.
(Unpopulated termination resistor positions are provided on eval board allowing
user to choose termination values to match).

I have attached a technical drawing / datasheet for the connector manufacturer
CUI.

Attachments

Outcomes