What should I do to SYS_CLKIN1 on SC58x, if I need only one CLKIN in my system

Document created by Nabeel Employee on Jul 10, 2015Last modified by Nabeel Employee on Jul 10, 2015
Version 2Show Document
  • View in full screen mode

Unused CLKIN pin should not be left floating. If only SYS_CLKIN0 is used in the system, then SYSCLKIN1 should be pulled down low. A pull-down of 10k or less should be used. As far as XTAL1 is concerned, it can be left floating as mentioned in the datasheet

Attachments

    Outcomes