FAQ: Why there is no Audio output after my Schematic is downloaded?

Document created by JJoseph Employee on Oct 6, 2014
Version 1Show Document
  • View in full screen mode

Q: Why there is no Audio output after my Schematic is downloaded?

----------------------------------------

A: Check the booting status of the LED. Refer to section 6.5 of SigmaStudio_for_SHARC_Users_Guide.pdf for more details on LED status. Reset the board and boot the SHARC Target again with correct Loader File. Refer to section 6.2 of the same document for more details about booting. Also check the audio channels number. Refer to section 8 of the document for channel numbering of the supported EZ-KITs. Also check the API version, I/O channels settings, etc. in the IC Control Window.

Attachments

    Outcomes