KCC's Quizzes AQQ305 about a mutual exponentiation equation
1. Quote of the month: "A train station is where a train stops. A bus station is where a bus stops. I have a work station on my desk, so..." - unknown
2. Quiz AQQ305 about finding a mutual exponential equation
Good luck, and try to be among the
View All
October Monthly Blog Quiz! Read the blog, take the quiz, and you could win a gift card
Finding Your Circuit Chi — EMC Quiz!
Think you know EMC? Test your knowledge with our 5-question quiz!
Read the blog first, then take the challenge: Finding Your Circuit Chi
Every current flowing creates electromagnetic fields.
Strong EMC design
View All

Try using the existing PNP symbol and .include statement (or copy model into the schematic).

I just manage to include the SPICE Model. I am not sure about Prefix. It is QP.
I am not sure if it is working fine or not.
In PNP transistor, to turn on the transistor, the base voltage has to be below -0.6 V. Such that emitter to base is +0.6 V forward bias. But in simulation it is not like that. It seems to be conducting.
When the transistor is not conducting (base voltage is higher then -0.6 V) the collector voltage should be the supply voltage.

Voltage for collector supply should be negative (-5V).
I have changed the supply to -5V then it start working.
I am still wondering about Prefix. It is QP. Do we have a list of Prefix for different devices ?

"QP is correct.
The first letter of the Prefix corresponds to the basic type of device, which is listed in the table on LTspice's Help page for "General Structure and Conventions". For all Bipolar transistors defined by a ".MODEL" statement, the first letter must be "Q". LTspice happens to use "QP" for PNP transistors and "QN" for NPN transistors, but anything after the first letter is irrelevant.
If your transistor had been defined by a ".SUBCKT", then Prefix would have to be changed to "X".