AD8561 output

Hi DRBB,

Thank you for raising this concern, I already sent an email to the designated applications engineer that is in-charge of this device to verify the concern and raise a corresponding report so we could address this in the model itself.

Thank you for using LTspice.

Best Regards,

Earl

Fantastic Earl - thanks for your help!

Hi DRBB,

Thank you for your patience on this. In case I'll get a reply already from the apps team then they shall raise the ticket for this to be fix, I'll take this ticket to I can address this in the modeling aspect.

Thank you

Hi DRBB,

I got an answer with our Apps Team, and this concern already has a ticket raised

For the meantime, while the issue is being addressed in the model, as per our apps team, you can use the LT1016 Model for comparison. This is discussed in page 7 of our datasheet.

I hope this one helps.

Best Regards,

Earl

Thanks Earl! I'll just use the complementary output as the output in the meantime as a workaround. Thanks for your help!

Thanks Earl! I'll just use the complementary output as the output in the meantime as a workaround. Thanks for your help!

Hi drbb ,

Good news, I had already fixed this issue, but we are still waiting for the verification of the part owner before we can release it, thank you for your patience.

Best Regards,

Earl

Hi drbb ,

The model for this part had already been updated on our library, you can update your model library on LTspice and see it there.

Thank you for your patience on waiting for this.

Best Regards.

Earl

Hi Earl,

that's great news! Thanks for your help with this, much appreciated.

Cheers,

Dave