AD-96TOF1-EBZ faild to connect to windows PC and could not run on Dragonboard 410c.

Question

I am using the AD96 TOF board with Dragonboard 410c. 
 After the DragonBoard boots up, i followed the course to press the S3 button on the camera board. But the DS4 LED did not light up and the USB carmera driver has not been loaded on the computer. 
 Then i used the linux system built into the dragon board. When i run aditof-demo.sh, the program flashed back, and the following error report is displayed before flashing back. 
 I used it normally a few months ago, but these errors occurred recently.

Septimiu Vana · Accepted Answer

Hello, Your eeprom with the calibration data might be corrupted, there is a tool that can overwrite it, it can be found here: https://github.com/analogdevicesinc/aditof_sdk/tree/master/tools/eeprom-tool You must rebuild the sdk with the WITH_TOOLS cmake flag enabled. You can find a backup with the eeprom content here: https://github.com/analogdevicesinc/aditof_sdk/tree/master/misc/ad-96tof1-ebz 
 Best regards, Septimiu.)