Reading the AD9959 registers

Hi sekou ,

AD9959 has 2 phases to a serial communication cycle. 

Phase 1 (Instruction Cycle):

1. Take note that each bit of the instruction byte is registered on each rising edge of the SCLK (Serial Data Clock). 

2. Instruction byte determines whether it is a read or write operation. It contains the serial address of the address register. 

Phase 2 (Actual Data Transfer):

1. The number of bytes being transferred during this phase is a function of the register being accesses. 

2.  The number of additional SCLK rising edges required for data transfer and instruction byte depends on the number of bytes of the register and the serial I/O mode of operation.

3. For example, when accessing FR2(it is 2 bytes wide), Phase 2 requires that 2 bytes be transferred, then communication cycles is then complete. 

It can be best described in this figure. 

All the best,

Jules

Hi Jules.Nikko , Ok I see that I indeed need to set the CS pin to Low for the read operation, I understand that each bytes is reading at a falling edge of SCLK and I understand each phase, I see from the datasheet that the t_dv time is 12ns maybe that's the key to my problem, I'll try to had a delay in my function.

Thank you

Jules.Nikko 

Ok the problem persist when using the HAL_SPI_Receive(), the received buffer returns 0. Before doing so however, I'am able to write at CSR with the value 0xF2, to enable all channel and for the single-bit serail mode (3-wire mode) I/O mode of operation. I can write to all channel a desired frequency and phase. 

My MISO is connected to the SDIO_2 , the SCLK to the SCK pin of the board and MOSI to the SDIO_0.

I transmit a read instruction to the board , do the bit D7 of the instruction byte is 1 and the first 4 bytes are the serial address of the register I want to read. It is implemented like this in my code:

uint8_t read_instruction = (READ_INST | reg_addr & 0x1F) with READ_INST = 0x80

then I set the CS pin to LOW and start the transmit and receive spi function from the HAL library but the receive buffer still have no value. 

I can share more of my code if needed to but for now im in a dead end. It looks quite simple as a task but it's not doing a thing.

I'll keep looking for a solution

Hi sekou ,

I can't think of other ways that might have caused this issue. I'll try to think and let you know in case I encounter other ways which might help. 

Also, I'm not familiar with the way STM32 works and their libraries but it might be worth checking if there are things needed for initialization and such. 

All the best,

Jules

Hi Jules.Nikko  I'm pretty sure the initiazation is done properly, but I'll check again. I manage to see the SPI signals, when I send the byte instruction for a read the MISO signal never updates for some reason

Hi Jules.Nikko  I'm pretty sure the initiazation is done properly, but I'll check again. I manage to see the SPI signals, when I send the byte instruction for a read the MISO signal never updates for some reason