Hello everyone, Can we program this board (AD9912 evaluation board) using Labview. What are other options through which we can interface or program. I need to write a program for automatic phase compensation. Can we give negative phase offset by using DDS board. My requirement is to work with 10 MHz frequency signal with phase compensation of the order of picosecond resolution. If anyone has other solution except DDS 12 or 14 bit, then please suggest me.
Apologies for the late response. We can suggest the following steps to program the AD9912 evaluation board using LabVIEW:1. Look to the FX2LP website to access their SDK. https://www.cypress.com/documentation/development-kitsboards/cy3684-ez-usb-fx2lp-development-kit2. Install the SDK so that you'll have access to the tools to create a custom firmware for the board.3. Refer to our product page for the evaluation kit information such as schematic. The schematic is very useful in determining the pin allocations you need to consider when creating the firmware.4. In LabVIEW, look for the .Net VI's. They are the ones that manages the .Net interface for the DLL coming from FX2LP SDK.5. You can then start programming the board.