AD9838 frequency control using LabView and SDPAPI1.DLL

I have a Blackfin Evaluation Board (SDP-B) connected to an AD9838 DDS. I would like to implement the frequency control outlined in AN-1070 using LabView and the SDPAPI1.DLL (.net library) provided with the boards. Using LabView, I can see the properties and methods of the DLL, but am not sure what the programming sequence should be. I'm guessing something like this: SDP->connect, write the control words using SPORT->writeU16, then SDP->disconnect. Any insights would be greatly appreciated.

Parents
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:33 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Reply
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:33 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Children
No Data