Need the command format for the AD9106

Question

I am going to be using the AD9106 with a micro controller. I have all of the info for the AD9106 but it is not clear to me how to send the commands and the format of the strings to the AD9106 to get it to work. Any examples would be great. Thanks again, Jim

LouijieC · Accepted Answer

Hi Jimmie, 
 The SPI protocol would allow you to access an individual register. Refer to page 21 of the data sheet for more information about the SPI. I'm not familiar on how PIC libraries are implemented but just look at their SPI libraries and make sure that the wordlength to use is 24-bit. (1 byte for the command cycle and 2 bytes for data cycle). I suggest to use the 4 wire SPI protocol for prototyping because of the fact that you're using a separate pin for reading SPI data. Rather than switching between input and output modes for a 3 wire SPI which adds timing considerations to your firmware. 
 Best Regards 
 Louijie)

EZAdministrator · Answer

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum. Thank you, EZ Admin

Electronic Design Services - PartnerZone

Products In This Thread

Need the command format for the AD9106

Top Replies