ad9954

I am  evaluating AD9953 chip. We have  AD9954 evaluation board for the same.

 

We are tried configuring AD9954 in  different modes,

we are not able to  configure in linear sweep mode because it requires  PS0 and PS1 pins toggling.

There is no option to set PS0 and PS1 pins in the AD9954 Evaluation GUI   

 

Pls share the options how we can configure linear sweep mode in ad9954 eval board@

  • 0
    •  Analog Employees 
    on Apr 20, 2017 11:31 PM

    Hi,

    On the Control window, check Enable Linear Sweep. Make sure that the correct DUT tab is selected.

    Then on the RAM/Linear Sweep Configure, the corresponding tab for the DUT selected will change to Linear Sweep Configuration. The sweep can now be controlled using the Ramp Down and Ramp Up buttons.

    Best regards,

    Mark