I trying to synchronzie 4 DDS of AD9910 ,but i am not yet there, i aligned the REFCLK of all of them
also the Sync out of the Master is connected to all the slaves by ADCLK846, I have made the SMP_ERR
Latch error bit go to 0 v. and for a minute every thing was aligned also at the Signal output, but when i changed
frequency it didn't save the alignement. I0_Updated is triggered to all the DDS's at once every update, even when one DDS recives information to the register all of the DDS'S get IO_UPDATE. but still at every frequency different phase between the signals and also sometimes one frequency that was aligned after changing the frequency and going back to it ,changes the phase alignment a little.
is someone familiar with this sequence
Thank You in advane
The preset register is intended to inject some specific phased difference. If you want them all sync'd, the make sure the preset registers are programmed the same on all the devices. You'll need to determine the correct settings for the SYNC receive delays after doing that.