Hello All,
I am working with AD5611. I wrote a code to adjust output of AD5611. When I try to send 466 decimal to AD5611 the scope screen capture is as follows.
Yellow is SYNC bar, Blue is CLK, Purple is SDIN and Green is out of AD5611. Some how on 8th falling edge DAC updates its output. I could not understand that?
I did couple of more tests it seems that AD5611 outputs differ time to time.
Hello Ian,
I am using custom hardware that I made. The schematic is as follows. R7 is not populated. Output is floating right now.
Voltage for AD5611 is 5V. I use ADR435 to supply 5V. My clock frequency is around 166Hz.
Output does not follow any logic right now. If I send 466 Sometimes I get 2.27 sometimes 80mV. Output stays like that does not change. When I set logic high the sync pin nothing happens. When I power up board and send first 16 bits sometimes nothing happens. sometimes after 6 th clock output update itself. sometimes 8th clock cycle. sometimes output changes on rising clock cycle too. I am hand soldering the IC. Maybe I damage the component but I am not new to hand soldering.
Hello Ian,
I am using custom hardware that I made. The schematic is as follows. R7 is not populated. Output is floating right now.
Voltage for AD5611 is 5V. I use ADR435 to supply 5V. My clock frequency is around 166Hz.
Output does not follow any logic right now. If I send 466 Sometimes I get 2.27 sometimes 80mV. Output stays like that does not change. When I set logic high the sync pin nothing happens. When I power up board and send first 16 bits sometimes nothing happens. sometimes after 6 th clock output update itself. sometimes 8th clock cycle. sometimes output changes on rising clock cycle too. I am hand soldering the IC. Maybe I damage the component but I am not new to hand soldering.
