I want use an AD5754R EVAL Board via SPI bus and program it with LabVIEW.
Where may I find the different control register in order to program it ?
It believe that the AD5754(component)' registers may be changed and not usefull, is this right ?
Thank you for the answer.
You may use the AD5754R data sheet in conjunction with the user guide for the EVAL-AD5754R. The registers are discussed on pages 26-29 of the RevE data sheet.
For the hardware part, you can use…
For the hardware part, you can use the connector J8 for programming the evaluation board.
Thank you for this answer. My problem is that I want use the ADC circuit(U6 /AD7323) to read back manual control voltage for my application.
So really I need all the set of command for the AD5754R Eval board (as I can find for the AD9959 Eval board which I already use in the same application [with SPI interface and an other adress bit : not CS] ).
As for the AD5754R:
I need the same register command for the AD7323.
Where can I find the information ? May I use the documentation of : http://www.analog.com/media/en/technical-documentation/data-sheets/AD7323.pdf ? Or is there a complete doc for the AD5754R Eval board ?
Of course, you may use the data sheet of the AD7323. I am curious though as to how are you going to probe the signals from the evaluation board?
If you have any questions regarding the AD5754R and its functionality, please do not hesitate to ask. If you have questions regarding the AD7323, you may post one in Precision ADCs.
Hello Mark, I have internet problems this week but I can answer you that I plan to use the LK2, 3, 4 & 5 to read out 4 voltages (manual) and a smaller resolution is sufficient.
I hope this can work...