Post Go back to editing

Troubles with AD5142

Hi! I cann't control AD5142 with stm32f4 by SPI. I connect AD5142 like rheostat in feedback of op amp (for amplifing). Scheme in attach. But when I send some data via SPI to AD5142 it don't answer and Vout isn't change. For change resistance, I send b0001000000000001 (in 16bit mode SPI in stm32f4), then I change data to b0001000011111111 and there is no result, Vout isn't change. Oscilloscope picture correct and looks same like in datasheet. What am I doing wrong? Is it necessary to send some preparation data to AD5142, before set resistance? Could some one post tested sequential data for change resistance in AD5142?

Parents
  • Yes, Reser and Sync are ok, I sure. Clock and SS are looking same like in datasheet - I sure. But I don't sure of correct data series. I try to write data to EEPROM and readback, but digipot isn't answer - SDO line is always LOW (Clock and SS are correct (16 bit)). Can you post correct data sequence to change EEPROM data and read it back?

Reply
  • Yes, Reser and Sync are ok, I sure. Clock and SS are looking same like in datasheet - I sure. But I don't sure of correct data series. I try to write data to EEPROM and readback, but digipot isn't answer - SDO line is always LOW (Clock and SS are correct (16 bit)). Can you post correct data sequence to change EEPROM data and read it back?

Children
No Data