AD5791: FAQ

  • Created
  • Updated
Was this helpful?
  • AD5791 daisy chain

    Question We are going to use 4 of this IC in the new design, and we need to optimize digital IO count. We were planning to use them in a daisy-chain structure until I saw in the datasheet revision…
  • AD5791 Noise?

    Question When operating the AD5791 in the Gain of Two Configuration see Page 26 Datasheet, rev. C) when VREFP = 10V VREFN = 0V AD8676 and AD8675 the measure noise is about 30 nV/Hz^0.5 at 1 kHz at…
  • AD5791 question re Gain of Two Configuration

    Question I have a short question regarding the AD5791 DAC IC. On page 26 of the datasheet it tells about the Gain of Two Configuration. The expression of the span appears as: from 2x Vrefn-Vrefp to…
  • AD5791: Get half of the reference voltgae by using the internal amplifier

    Question I am using the AD5791 in an application which incidentally also requires a precise reference voltage that is exactly half of the positive reference voltage of the AD5791. Is there any reason…
  • AD5791: Recommended reference

    Question 1. For ADI's Reference chip, as below shown figure , Seems ADR423 and ADR440 is our best part, whose TC is 1 ppm, noise is 1 uVpp. The initial Accuracy is only 0.05%, long-term stability is…
  • EVAL-AD5791SDZ for arbitrary function generators

    Question Can I send a data file (like excel) to the folowing products: EVAL-AD5791SDZ EVAL-SDP-CB1Z Does it work like a arbitrary function generator? Answer As far as I am aware, this is not possible…
  • LTZ1000 on AD5791 Eval Board

    Question I've bought a AD5791 20bit DAC Evaluation Board to evaluate the AD5791 for a new product design. Later, I would like to use a LTZ1000 as reference in the new product. I saw that there are…

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.