• State Verified Answer
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 74 subscribers
  • Views 457 views
  • Users 0 members are here
Options
Related

Is there a LTSpice model for the AD7495 or at least a LTSpice model for the Vin? I am using the 2.5V RefOut with a resistor voltage divider for the Vin pin and I am seeing less than 1/2 of the reference. I do not see a spec for the input impedance of the

technobob
on Jun 29, 2018

I am sampling the ADC at 1Mhz, I have a 30K resistor from the RefOut pin to another 30K resistor to gnd. On the center tap between these resistors I have a 1K resistor into the Vin pin. I am seeing 1.084V on the Vin pin. When I remove the 1K resistor (isolating the Vin pin from being in parallel with the lower 30K resistor) the divider is correct  at 1.25V.

Top Replies

Parents
  • 0
    •  Analog Employees 
    on Aug 24, 2018 12:51 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Reply
  • 0
    •  Analog Employees 
    on Aug 24, 2018 12:51 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Children
No Data