I hope that I'm in the right place
I have a question regarding the Linear LTC2324-12:
I'm using the internal reference (my case is 2.048V) - can I use REFOUTx as an input for resistor division? please see the attached file configuration?
I am the apps engineer for this part. What you propose is fine. I would use at least 4.7uF bypass at each REFOUT pin.
Thank you for your response,
The data sheet states a 10uF for each REFOUT so we're good.
Can you say how much current each REFOUT pin can source?
The output impedance of this pin is typically 0.25ohm. I can't really cite an accurate "maximum" output current, but I would draw no more than a couple of mA from this pin.