Hello
I had SDP-K1 and EVAL_AD4080ARDZ in hand now.
I had tried to see same capture on EVAL_AD4080ARDZ users guide Fig11 in the Attched Hardware Panel ....,
but ' No daughter board detected ' yet.
Would you please adivise?
My procedure is followings,
1) Install ACE Installer software 1.30.3369.1491 in advance
swdownloads.analog.com/.../ACEInstall_1.30.3369.1491.exe
2) Then, click the ' board.ad4080.1.2026.421203.zip' which is downloaded from website in advance.
www.analog.com/.../board.ad4080.1.2026.421203.acezip
3) Set EVAL_AD4080ARDZ on the SDP-K1 , then Plug in 12V supply. ( SDP-K1 I/O jumper P14 is 3.3V like as Fig10 on users guide in advance )
4) Plug in USB cable to PC. user
LED DS1 on SDP-K1( orange) is on. (connected)
LED DS2 on SDP-K1 is on. ( power on)
LED DS1,2,3 on AD40800-ARDZ is on (blue,green, blue)
5) I can see ACE Tinyiiod firmware required pannel, click OK, wait 5-sec, but nothing changed in the attached Hardware panel. ..... see attached
Q1
Do you think I had to drag & dop any firmware file into SDP-K1 (D:) manually when I insert usb cable??
If yes, please give me its file.
Q2
Do you think my procedure 2) is wrong?( Not necessary?) I had tried to follow page 10 of EVAL- AD4080-ARDZ, but
I coud not follow " ACE slidebar-select packages" ( nothing started.. so I had clicked plug-in ).
Thank you for your support.
Best Regards
