Category: Software
Product Number: AD4111
Hi,
I am exploring the behavior of the DOUT_RESET in AD4111. I understand from the datasheet that enabling this bit causes the DOUT/RDY pin to remain in data output mode until the CS pin is brought high.
However, I would like to gain a deeper understanding of this method and its practical use cases.
- Are there specific application scenarios or microcontroller interface limitations where setting DOUT_RESET = 1 is strongly recommended or even necessary?
- Are there any downsides (e.g., performance or power implications) to always keeping DOUT_RESET = 1 regardless of MCU speed (faster MCU)?
- Is there a recommended approach or guideline for when to enable this bit based on the system design?
Regards,
Lumi
