Post Go back to editing

AD7606C-16 || Digital Data to Voltage Conversion

Category: Hardware
Product Number: AD7606C-16

Hi Team,

I am using AD7606C-16 ADC IC for my receiver system.  I want to validate the ADC-received samples to my scope waveform. I am doubting what should I consider the value of Full Scale Range in the calculation formula.

Please Note: I haven't made any configuration changes for the ADC IC. 

Conversion formula:

Voltage= (Digital Data)* Full Scale Range / ((2^16)-1)

In the Oscilloscope I am seeing Vpp (measured at P wrt N I/p of ADC) is ~3.0Vpp

I am attaching the Digital Data, Pls suggest are the samples Ok. What Should I consider the Full Scale Range for my calculation?
CONVST Freq: 108KHz
Input Frequency: 27KHz

Parents Reply
  • Hi Lluis,

    After step 6, I not doing any more writing operations, so my SDI line is low. 

    For ADC mode I am using only DOUTA, DOUTB, after doing the above registers write operation, DOUTB line is low, only toggles are observed on DOUTA (data seems similar to what I wrote to the registers). 

    My convst pulse is at 108k, 

    I will send you the snapshots by EOD.

    I am planning to probe SCLK & DOUTA. Anymore probe shots you are looking for