ad2s1210 schematic check in SPI mode

Hello,

I'm working on a STM32 board that will work with ad2s1210. Never use this chip before, so I ask you if my schematic is ok.

As reference I've use the eval board https://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/eval-ad2s1210.html schematic and this article https://www.analog.com/en/analog-dialogue/articles/precision-rtdc-measures-angular-position-and-velocity.html

I plan to use ad2s1210 only in SPI mode.

1. Can it be used only in configuration mode?
2. To activate the configuration mode I've pulled up A0, A1 and also RES0 and RES1 can be pulled up cause I'll set all by registers. Is that right?
3. About the SIN/COS input, I've put the 220p as RC filter, is that a 2k over 220p filter, so 361kHz filter, right?
4. About the SIN/COS input, instead of the RA attenuation resistor I've put three resistor selectable R15 R73 R74 (for SIN), Is that a partitor with 2k resistor (1k+1k from input)?
5. Do you find any other issue?
   

Thank you for your help!