DC590B & DC2094A Msg : Cannot load COM module for the device

Hi, 

This is interesting as I think we have similar threads here. 

https://ez.analog.com/data_converters/precision_adcs/f/q-a/560617/cannot-load-com-module-for-device-when-connecting-dc2365a-to-dc590b  

Can you check if searching and downloading the .msi will help? 

andreialejandro  Can you help/assist on this please, along with the attached thread? 

Thanks,

Jellenie

Hi Jellenie,

By mistake I replied in other thread that you sent me the link for. Those links are specific to certain DCXXXXX, and specific installer was provided for corresponding DCXXXXX. I still could not find solution for my DC2094A-D. Please send me a link similar to https://ltspice.analog.com/quikeval/insXXXX.msi so that I could proceed with my evaluation for DC2094A-D (LTC2348-16).

Thank you. 

Hi,

The software can be downloaded directly here: https://ltspice.analog.com/quikeval/ins2374.msi

After downloading and installing the software will be available from the START menu in the Linear Technology folder.

Hi,

The software can be installed from here: https://ltspice.analog.com/quikeval/ins2374.msi

After downloading and installing the software can be run from the Start menu in the Linear Technology folder.

What is written in the EEPROM in the DC1812A-B module? If I use the LTC2944 directly as a product, I want to connect QUILEVAL or the LTC2944MSI software directly, without this EEPROM, is it possible?

In fact, without the EEPROM on the DC1812 module, the two upper computer software cannot be opened, and the display shows LTC Devices not found, which is a very strange phenomenon.

The eeproms contain board and part information that PScope and QuikEval use to load the proper module and interpret data from the board.