I was looking into the AD7606 eval board. I could not find a suitable method to evaluate the ADC board in standalone mode. Would appreciate if guidance is provided
Would you considered using AD7606B/AD7606C-16 device instead of AD7606? It´s newer and more functionality added (offset/phase/gain calibration, diagnostics, open circuit detection). Besides,…
You can remove them, yes. These 10K resistor would pull down the line to ground, so no need. The ACE software distributed can use both serial and parallel interface without HW modifications.
I think the product owner is currently on a leave.
Have you seen this post before? (+) Working with EVAL-AD7606SDZ in standalone mode - Q&A - Precision ADCs - EngineerZone (analog.com)
If you are using similar board then that thread help you get started.
We also have some available codes that you can use as a reference.
I was referring to the link https://www.analog.com/media/en/evaluation-boards-kits/evaluation-board/EVAL-AD7606SDZ-RevA-SCH.pdf. I did not find p1 and p2 connector