Post Go back to editing

Use of TL431 for voltage reference of AD7683

Thread Summary

The user inquired about using the TL431 voltage reference for a 5V Vref input in the AD7683 ADC, questioning its noise performance. The TL431 is not suitable for a 16-bit ADC due to its 50 ppm/°C tempco and higher noise. The final answer suggests considering the ADR3425 or ADR4525 for better performance, and to integrate the noise over the system bandwidth as shown in the TI datasheet's noise curve (Fig. 7).
AI Generated Content

Hi,

I am interesting to use TL431 voltage reference to generate 5V to be used in Vref input of AD7683.

This voltage reference has low noise voltage enough for AD7683?

I am asking because many voltage reference devices inform noise voltage parameter, normally in a specific range of frequency and in micro volts.

For example, ADR435 device, from Analog: Low noise (0.1 Hz to 10.0 Hz): 3.5 µV p-p @ 2.5 V output.

Unfortunatelly, this information does not informed in the TL431 datasheet. I tried TI, OnSemi, etc...

Regards,

Parents Reply Children
No Data

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.