Problem AD7892 serial mode

Hello! Could you help me with the implementation of a consistent regime AD7892 chip. I connect it to the microcontroller ATmega129. Follow all the instructions written in Datacheet, but the data on the chip is not transmitted. Tell me what could be the problem, I can send a detailed wiring diagram and program listing for the microcontroller.

Parents
  • All right thank you very much for your help. It was out of whack contacting device, it is not pinched the leg selection mode thereby leaving it in limbo. Thanks again for your help, almost all the problems in electronics because of contact where it should not be, or because no contact where it should be)))))

Reply
  • All right thank you very much for your help. It was out of whack contacting device, it is not pinched the leg selection mode thereby leaving it in limbo. Thanks again for your help, almost all the problems in electronics because of contact where it should not be, or because no contact where it should be)))))

Children
No Data