I have purchased the ADAS Evalboard, but I am not sure how to use the device to record all 12 ECG leads?
The register values are the same as on the User Guide (Figure 14)
Master ECGTL Register: F800BE
Slave ECGTL Register: F000DE
Should the slave have a different register value to include all 12 leads?
Can you please help with the steps I need to follow to get this working, it would be greatly appreciated.
Thanks in advance
I believe you are interfacing with your own controller? (not using ADI SDP/Software?)
I'm attaching the Gang mode settings we use for ADAS1000 Master/Slave devices in our own software.
There's lots of information in the datasheet also about gang mode and also a section included in the examples section on page 76, be sure to read the information to sequence both devices into gang mode properly - it is important how they are configured and how the writes are issued (Master ecg conversion must be last).
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