ADAS1000 clock problem

Question

Hi, I'm using ADAS1000. Unfortunately when did place board component, I placed crystal wrong and cause short circuit between XTAL1 & XTAL2 pins. 
 Now I'm trying to connect ADAS and get data from it. I get frames but only have headers and crc value, but other data is zero. So I think that is maybe for clocking and check xtal1 & xtal2 pins signals with oscilloscope. There is no signal on this pins and I think ADAS is damaged (The Operating State Register return 0x000004). 
 What can I do? Is there any way to repair or run it? 
 Thanks.

CatherineR · Accepted Answer

Hello, 
 Are you applying a clock to the CLK_IN pin? 
 I wouldn't expect shorting the XTAL pins to damage to the device, the XTAL circuit won't be able to work - and obviously this is not how it's intended to be and would need to be corrected in the design. 
 
 If you are able to apply a clock to the CLK_IN pin to see if you can get the conversions running, (ensure you enable conversions), that might help you confirm the other operation of the part. 
 
 hope that helps.. 
 best regards, 
 Catherine)

Partner Forums

Partner Libraries

Products Mentioned

Associated Drivers

Associated Drivers

ADAS1000 clock problem