If the decimation factor N is a non-integer number, the period of the DRDY oscillates between the periods determined by the integers obtained rounding up or down the decimation factor.
The average of…
In the datasheet the equation to calculate the temperature can be found.
This equation calculates the temperature rise referred to 25°C, so to calculate the absolute temperature it is necessary…
Daisy-chaining devices allows numerous devices to use the same data interface lines by cascading the outputs of multiple ADCs from separate AD777x devices. In daisy-chain configuration, only one device…
To synchronize multiple AD777x, an external pulse in the SYNC_IN pin is required. This pulse does not affect the data programmed in the internal registers and must be synchronous with MCLK.
There are…
Once the device is power-up it is possible to communicate with it via SPI even if no RESET is done although it is highly recommended to reset the device to ensure the proper initialization of the digital…
The AD777x family provides a PGA per channel which can be independently configured.
The PGA is a capacitive programmable gain amplifier offers a good performance, including high common-mode voltage rejection…
The AD777x already integrates a 2.5V +-10ppm reference. The reference is internally buffered and available at Pin REFOUT.
The buffers can be set in three different modes.
In Fully enable mode, no…
It is possible to disable any channel which will help reducing the total power consumption, but this will not stop the data of those channels being output even if the pins are left open or connected to…
The PGA gain 1 of each channel is trimmed independently in the factory. This value will be loaded in the registers CHx_GAIN_UPPER_BYTE, CHx_GAIN_MID_BYTE, and CHx_GAIN_LOWER_BYTE after a RESET.
The gain…
The AD777x does not have any power sequence requirements.
The only thing recommended is to make a RESET followed by a SYNC command (via HW or SW) after the supplied voltages are stable to load the default…