AD9121-M5375-EBZ: bypassing the Balun

Question

Hi, 
 we want to use the AD9122 Evaluation Board but we want to bypass the Balun (red box in image below). I have pasted screenshots from the schematic of the Eval-Board Ref F, pages 6 and 7:

I wanted to know if this is possible by using the right jumper configuration (green boxes). In the manual I cannot find anything about this, so I was wondering. 
 
 Thank you very much!

zpandangan · Accepted Answer

Hi diddo , 
 Thank you for using AD9121. 
 I wanted to know if this is possible by using the right jumper configuration (green boxes). 
 That is correct; T7 can be bypassed by using the on-board filter (pins 1 and 2 of JP6 and JP17 connected) and routing the output to SMA connectors J3 and J5 ( pins 1 and 2 of JP13 and JP14 connected ) if you opt not to use the ADL5375 modulator. 
 Regards, Zaeefa)

Partner Forums

Partner Libraries

Products Mentioned

Associated Drivers

AD9121-M5375-EBZ: bypassing the Balun