AD5372 evaluation software not working properly.

Hi AlexandrosS,

you can sense the value of Reset, Clear and LDAC signals in the J3 pin header to check if the SW is setting the correct values.

Regards

Paco

Upon the first launch LDAC and CLR are 0 and Reset is 1,4.
Upon the second launch all of the signal are high

In your application, what controller are you going to use? FPGA, MCU,...? I am asking because sometimes is easier connect directly the controller to J3.

I'm going to use a Rpi 4

if you have any question on the registers to write, just let us know.

Thanks :) . I might need some help with the connections and gpio commands.

I can help with the DAC side, unfortunately I have never used a RPi for SPI