The output observed on the pins OUT1_P/OUT1_N/OUT2_P/OUT2_N of AD9785 is always high before and after programming.

Question

Whenever I am probing the output on L1,L2,L3,L4 connected to the pins OUT1_P,OUT1_N,OUT2_P,OUT2_N it always shows 3.3V before and after programming. I have cross checked every connection as per the reference schematic and nothing was changed significantly. 
 Please let me know your thoughts on what could be the issue.

ShineC · Accepted Answer

Hi psrt1995,

I noticed you did not connect load resistors to the main DAC outputs. The output compliance voltage for the main DACs is up to 1V. So if you are operating in a full-scale output current of 31.66mA, there should be 30.1Ω load resistors connected across IOUTP and ground and IOUTN and ground.

Regards,
Shine

Partner Forums

Partner Libraries

Products Mentioned

The output observed on the pins OUT1_P/OUT1_N/OUT2_P/OUT2_N of AD9785 is always high before and after programming.