Post Go back to editing

AD9683 dev board (with FMC connector) design files

Hello,

I hope that everyone is doing great.

I am writing to ask where I can find design files (schematic, layout, BOM) of the AD9683 dev-board with FMC connector.

Here (https://wiki.analog.com/resources/eval/ad9683-170ebz_ad9683-250ebz_ad6677ebz) I can see that there is a dev-board available with the FMC connector. However, looking at the schematic here (https://www.analog.com/media/en/technical-documentation/evaluation-documentation/EvalAD9683_EvalAD6677_schematic.pdf) I see that it has the TYCO Z-PACK backplane connector.

Could you please point me to a location where I can access the required files? I would like to interface the AD9683 dev-board with FMC connector to a Xilinx FPGA dev board with the PCIe interface.

Many thanks in advance for any feedback.

Best regards,

Krzysztof

on May 27, 2021 2:26 AM in reply to omer

Hi Omer,

You can purchase directly to Analog.com site but only limited up to two boards. But please note that prices may vary.

As previously mentioned, you should only be able to purchase FMC version at this time.

Regards,

Meriam

  • FormerMember
    0 FormerMember on May 27, 2021 3:46 AM in reply to ksielewi

    Hi Krzysztof,

    Thanks for your interest in AD9250 as well. Please see attached .brd file of the eval board.

    Regards,

    Meriam

    AD9250_Eval_Brd.zip 

  • Hello Meriam, 

    thank you for the comment. It seems there was a mismatch at the distributors side and it has been now clarified, I have purchased and waiting for the board:

    https://forum.digikey.com/t/ad9683-250ebz-nd/14369

    Best Regards,

    Ömer.

  • Hi Meriam,

    many thanks for your help!

    I have one more question about AD-FMCJESDADC1-EBZ development board. I see that it's obsolete and not available but could you please still send me its schematic/bom/layout?

    Many thanks is advance!

    Best regards,

    Krzysztof