I tried to bring up AD9213 with the ADS-V1EBZ to acquire the baseband data.
I followed the quick start guide on ADI wiki.
My settings and steps were following it.
I used a typical LVDS REF 625MHz and 10GHz sampling clock.
The TMU is working normally, showing temperature dynamically.
The PLL locked/valid LED are also green light in ACE tool.
But after I followed step 21.C click Run Once, nothing showed up in the time domain view or FFT.
The tool then hung up for several minutes.
I updated JESD link status and the button turns red in GT RXRESETDONE Error/CGS Error/ILAS Error.
I tried disable ACE -> turn off the board for multiple times, but still cannot get data from the “Proceed to analysis” tab.
I tried the steps below, the TP5 seems to be alright.
I also updated ACE to the latest version and restart computer.
- If after repeated attempts the ACE startup procedure is not successful:
- Check that the jumpers are placed on the AD9213/9217 evaluation board as shown in step 4.
- Check that all signal generators are on and at the correct frequencies and power levels. (EXTCLK LVDS 1.43VDC)
- Check that 3.3V appears at TP5 on the Regulator Board. (measured 3.25V)
Or is there any suggestions for debug?
Is there DC test mode or default SYSREF source that I can use on ADS8-V1EBZ eval board?