I'm interested in using AD9562 in a research project. I have adquired AD9265-105EBZ and HSC-ADC-EVALCZ boards and I have obtained really good results using VisualAnalog. However my application requires to use AD9265 with LVDS outputs mode ( not supported by AD9265-105EBZ that uses only CMOS output mode) so I would interested in a "Evaluation board" that uses LVDS output mode to check if, finally, this converter mets all the requirement of my application. Is it this board available? Is it possible to use VisualAnalog to test the converter when LVDS outputs mode is selected?
Thanks in advance for your answer
Unfortunately we do not support an LVDS version of this EVB nor the LVDS FPGA source code required to configure the EVALCZ for LVDS using this part.
That said................your results should be equal (if not slightly better) for LVDS output since LVDS output is a "balanced differential output" that results in lower "supply noise" on the DRVDD driver supply.
I believe this is the case with AD9268 evaluation board also??
I would like to evaluate AD9268 in LVDS mode, but the EVB doesn't permit.