HSC-ADC-EVALCZ + AD9272 trigger sync

Question

Hi 
 I am following the steps that is on the document that I attached. 
 But the SPI Conteroller does not wirte the value to the board. (Every bits are 0 when I read even for the ChipID) 
 I activated the error massage, it shows the SPITransfer() error "The transfer bit did not get reset, Check encode". (I attached the screenshot) 
 Could you tell me what is the problem of write/read register function? 
 I am using "Octal_High_Speed_20151104_1315.bin" file for FPGA.

EZAdministrator · Accepted Answer

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin

Electronic Design Services - PartnerZone

Products Mentioned

HSC-ADC-EVALCZ + AD9272 trigger sync