I didn't succeed to capture AD9208 data using the attached test setup and the following test conditions: Fclock = 2625MHz, FPGA global clock = 328.125MHz, Full BW mode, L=8, M=1, F=1, N'=16 (as recommended in the wiki page). The clock signals have generated with an AD9530 PLL evaluation board. I have used this ACE installer version : http://swdownloads.analog.com/ACE/ACEInstall_1.7.2585.1050.exe
I have the same issue with an AD6688 eval board. When I click on run once button the SW didn't stop without displaying any error message. Please advice asap as my project is blocked due to this issue ...
Yes for AD6684 spi programming from Matlab.
But not for AD6684 data capture from Matlab.