SDP-H1 FPGA_DONE

Hi daaniellee,

Thanks for reaching out. Both the Done and Ready LED should light once the 12V supply is connected to the EVAL-ADMX100X-FMCZ.

Can you double-check that there is no jumper connected to P10 (JTAG BOOT)? This jumper should be open during normal operation. 

Try not connecting the SDP-H1, just the Eval-ADMX100X-FMCZ and the ADMX100X module with 12V supply. Check if both LED is turned on. 

If you can send me picture, including the jumper settings of the board, that would be helpful. 

Best regards,

Emman

Yeah so, on the ADMX board both of the LEDs come up. its on the carrier/interface board (SDP-H1) where the FPGA_DONE led isnt illuminated.

Hi, so in parallel with submitting this ticket i asked my corporate IT team to build me a windows 10 machine to test with, and the board works just fine with windows 10. it seems to be a windows 11 compatibility issue. 

Hi, so in parallel with submitting this ticket i asked my corporate IT team to build me a windows 10 machine to test with, and the board works just fine with windows 10. it seems to be a windows 11 compatibility issue.