AD5933: FAQ

  • Created
  • Updated
Was this helpful?
  • AD5933- Calculating Calibration Resistance Values

    Hello, I am using the AD5933 Impedance Analyzer and the corresponding evaluation board EVAL-AD5933EBZ for my senior design project. We were able to follow the example measurement for a 15 pF capacitor…
  • AD5933: DC Output Impedance

    Q I use AD5933 to measure an impedance Z1,at the same time I connect a capacitor between Pin Vout and Pin AGND for special purpose,and the value of capacitor is changeable. Will AD5933 still work correctly…
  • AD5933: Measurement of Capacitance and Resistance

    Q We built up an application of the AD5933 impedance to digital converter IC. We already tested the device using standard resistors soldered directly to the pins of the AD5933. Unlikely the imaginary…
  • AD5933_AN847 equation6 error

    Q In AN-847's 6th page, there are several formula, I think the "8mV" should be 800mV, isn't it? A yes these are typo's or errors. For range 2: Equation 6 on page 6 of 12 should have read Output…
  • RE AD5933 Capacitance Measurement

    Q As we know that AD5933 can measure both the magnitude and phase of impedance. So, I would like to know if we use this information to estimate the resistance value and capacitance value when a RC network…

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.