Question:
How should the unused input and outputs on the MAX9112EKA+T be terminated?
Answer:
The DIN_ data input should not be left floating because it's a TTL/CMOS input, instead it is best to connect to VCC or GND. The DO_+ and DO_- LVDS outputs should be left unconnected.
Learn
Libraries
Upcoming Learning & Events
- Power Integrity: LDOs for AI Infrastructure, Edge & Robotics
- The Missing Middle in AESA Development: From Beamforming ICs to Scalable Apertures
- Motor Drive Fundamentals Session 3: Safe Torque Off Architecture and Claiming Fault Exclusion
- Motor Drive Fundamentals Session 2: Designing for EMC Success in Modern Motor Control Systems
- View All Webinars
Community Hub
Resources
Challenge Yourself
KCC's Quizzes AQQ305 about a mutual exponentiation equation
1. Quote of the month: "A train station is where a train stops. A bus station is where a bus stops. I have a work station on my desk, so..." - unknown
2. Quiz AQQ305 about finding a mutual exponential equation
Good luck, and try to be among the
View All
What's Brewing
September Monthly Blog Quiz! Read the blog, take the quiz, and you could win a gift card
Quiz: How Well Do You Know Adaptive Power Switching?
Is your I/O module overheating? The AD74416H's Adaptive Power Switching (APS) can cut heat dissipation by up to 40% — but how well do you really understand how it works?
Read the blog first: Cooling
View All