Since MAX31865 registers require setting up, it is not possible to use only 3 wires for SPI communication; Two wires are needed for chip select and clock, and the other two are required for setting up the registers and reading data back from MAX31865. However, it is possible if DRDY pin is not used. In this case, the microcontroller should wait maximum conversion time before reading each sample. The maximum conversion time depends on the mode the device is in. Refer to "Temperature Conversion Time" specification in Electrical Characteristics table of the datasheet. Note that in 1-shot mode, initiating each conversion will require writing to the register.
Learn
Libraries
Upcoming Learning & Events
- The Missing Middle in AESA Development: From Beamforming ICs to Scalable Apertures
- Motor Drive Fundamentals Session 3: Safe Torque Off Architectures and Claiming Fault Exclusion
- Motor Drive Fundamentals Session 2: Designing for EMC Success in Modern Motor Control Systems
- New Lowest-Power ZIF-Based SDR Transceivers for RF Instrumentation and Defense Applications
- View All Webinars
Community Hub
Resources
Challenge Yourself
KCC's Quizzes AQQ304 - A pure logic
1. Quote of the month: "I am not lazy, I'm just in energy-saving mode" - unknown
2. Quiz AQQ304 about finding a pure logic puzzle
Mike is looking at Anne, but Anne is looking at Paul.
Mike is married, but Paul is not.
Question:
Is a married
View All
What's Brewing
September Monthly Blog Quiz! Read the blog, take the quiz, and you could win a gift card
Quiz: How Well Do You Know Adaptive Power Switching?
Is your I/O module overheating? The AD74416H's Adaptive Power Switching (APS) can cut heat dissipation by up to 40% — but how well do you really understand how it works?
Read the blog first: Cooling
View All