在使用ADG849时出现以下问题：
实现功能：ADG849供电电压为3.3V，S1接入3.3V，S2接入5.5V，D端作为电源输出端用来实现两路电源的切换；
问题：出现3.3V供电电压被抬升到5.0V的问题，其中S1与VDD接在一起。
groupUrl: https://ez.analog.com/cn/support-reference-library/switches_multiplexers/
- Home
- Blogs ⌵
- Browse ⌵
-
Support ⌵
- 3D ToF Depth Sensing
- A2B
- Aerospace and Defense (ADEF)
- Amplifiers
- Analog Microcontrollers
- Analysis Control Evaluation (ACE) Software
- Audio
- Clock and Timing
- Condition-Based Monitoring
- Data Converters
- Design Tools and Calculators
- Direct Digital Synthesis (DDS)
- Embedded Vision Sensing
- Energy Monitoring and Metering
- FPGA Reference Designs
- Industrial Ethernet
- Interface and Isolation
- Low Power RF Transceivers
- MEMS Inertial Sensors
- Motor Control Hardware Platforms
- Optical Sensing
- Power Management
- Precision Technology Signal Chains
- Processors and DSP
- Reference Designs
- RF and Microwave
- Signal Chain Power (SCP)
- Switches/Multiplexers
- Temperature Sensors
- Video
- Wide Band RF Transceivers
- Wireless Sensor Networks Reference Library
- About EZ
- More
- Cancel
