I use the adf4355 board, download the corresponding software and driver according to the instructions, and change the frequency I want to output on the control panel. But no matter how I adjust, the output frequency is a value can not be changed
I use the adf4355 board, download the corresponding software and driver according to the instructions, and change the frequency I want to output on the control panel. But no matter how I adjust, the output frequency is a value can not be changed
Hi,
Do you see SDP connector connected message as given below example?
Regards,
Kudret
Hi,
Yeah, on my control screen, as on yours.
When i input 4000M and 6000M, the spectrum analyzer shows no change.
As shown in the figure below.
Hi,
Yeah, on my control screen, as on yours.
When i input 4000M and 6000M, the spectrum analyzer shows no change.
As shown in the figure below.
