help:Adl5605 output port short to grond

  1. I used chip adl5605 out  the transceiver to amplify the signal to high level, it will be damaged which it is normal working at first sometime. check the power supply. ok for  always5V. 
  2. have any one met same phenomenon.? 
  3. could share some debug items for me? 
Parents Reply
  • 0
    •  Analog Employees 
    on Dec 9, 2019 1:21 PM in reply to snow8321

    Hi Snow8321,

                            How are you measuring the power level? power meters usually measure the average power not the peak power. Are you accounting for the duty cycle in your measurement?

    It is also possible your board may not have adequate heat transfer to remove the heat from The ADL5605.

    Regards,

    Jim B

Children