Question
1 . Is the output for the external low pass filter a current or a voltage?
2. How is the maximum and minum voltage that can be presented in reference and
CK2?
3. RcPSet in my case is 5.1 Kohm how can i change it?
Answer
Question 1:
This is a Voltage ouput with a 100ohm Load.
Question 2:
The balum is a 1:1 balumn , therefore the spec's in the datasheet hold for
this input - which is 150mV input range, as the Device is selfbiased.
Question 3:
See datasheet page 50 = CP_lsb = 3.06/CPRset - This is all you need to insert
your own CPRset.