Question
My receiver signal may have some "errors" introduced due to various factors
Can the ADN2817 be able to remove and "clean up the signal".
Hence Can the CDR remove errors seen on its inputs so that its output is
effectively cleaned up and thus error free ?
Answer
The ADN2817 ia a Clock and Data Recovery ICs.
Its intended operation is for data and clock recovery (i.e. decoding and
separation of data and clk). Hence where these two signal are original encode
from.
Please note there is no error correction function with this IC. It will however
it clean up and separate individually the data and clock lines.
If there are bit errror enbedded in the encoding data. This is most likey to be
propagate after CDR.