AD9540 EVAL not detected

Question

Hello to all, I recently purchased an AD9540 eval board, due to clock generation. As I red in the forum, I follow the AD9956 procedure to install sw and power connection and sw finds the board via USB, but I see in red "NO MASTER DUT DETECTED". 
 Do you have any advices for me? may be I do something wrong during initialization. 
 Is there a special sequence for powering? 
 Thanks a lot

EZAdministrator · Accepted Answer

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin

neilw · Answer

Hi Luca, 
 Before you change over to the AD9956, verify the following jumper settings: 
 W2: installed 
 W3: installed 
 W4: Set to PC 
 W15: installed 
 The link just worked for me. It automatically starts a download, but you can navigate to ftp://ftp.analog.com/pub/CSS/Software/Support/EvalBoard/Programmers/ and select USBEvbdProgrammerSetup2.1.0.2.exe

Electronic Design Services - PartnerZone

Products In This Thread

AD9540 EVAL not detected