Post Go back to editing

Question of RESET for AD9508


Can anyone check this spec on your document or asking to your designer?

Our customer is still waiting since last week end .

I think that it is "unknown state" during your RESET is done, correct????  

Thanks Kaos


Dear Sir/Madam,

Our customer asked as following question.

Your AD9508 have the RESET pin.
So when the RESET pin is Low, then are your OUT0 to OUT3 set to high-Z, or not?
Otherwise OUT0 to OUT3 doesnt toggle so fixed to LVDS-output level, correct?

I cannot catch this answer on your datasheet well.

Thanks Kaos