We have this evaluation board. I'd like to know the supported communication protocol for this board.
And I'd like to test the same with arduino UNO board first (before going for regular micro-controller).
Please advise me the connections for the supported communication protocols and how to read the pH value and temperature.
Please suggest me with power supply to this evaluation board also.
Thanks & Regards,
CN0326 supports SPI digital communication.
For more information about how to setup the hardware and where to get a sample code using ADICUP3029, kindly visit the link found below:
Thank you, Erbe.
But, I've only this Evaluation board(EVAL-CN0326-PMDZ), not purchased other boards(EVAL-ADICUP3029 etc).
I don't have the Software also. And I'd like to communicate via Arduino board SPI communication and later with a micro-controller board, after successful test with Arduino.
Kindly advice me a hardware circuit and code to test with Arduino and EVAL-CN0326-PMDZ alone using SPI communication.
I hope you understood my requirements.
Thank you for kind support.
Here is the table that shows hardware pin map for J2 male header connector:
For more information about its hardware, you can visit the following link:
The current device driver and library for CN0326 is currently compatible with ADICUP3029 which is one of the ADI low power MCU and also is in Arduino form factor. Those files can be used as a reference so that you can easily migrate the source code to other MCU as it runs in a standard C language. Here is the link from GitHub where you can visit those device drivers and libraries implemented using ADICUP3029:
CN0326 uses AD7793 as its data converter. Here is the link from GitHub which shows you how it was initialized, calibrated and how it read back the data after taking a sample from its input
Let me know if that helps.
Let me check and comeback to you.
Thanks Once Again,
Just want to check out with you if your concern regarding the source code already resolved.
As some other projects are in line with tight schedule, I'm unable to test this.
Let me update you when i'm back to this (very soon) project.