We have set up EVAL-CN0359 and have the following problem. We are measuring the voltage from J5 pins 2 or 3. These feed AD8253. We see the expected distorted square wave on the scope but it is floating up and down between the rails. Page 18 of the datasheet for AD8253 possibly implies that the inputs are not stabilized by a bias current path to ground in the CN0359 layout. See also fig. 6 of your article by Kitchin concerning "Common Problems When Designing Amplifier Circuits". Any advice here? Thanks--Fritz
Is there a conductivity probe connected on J5? If there is, can you send me the product page for it? Also, can you send a snapshot from the signal captured on your scope? I'll try to recreate the cause of the floating effect you're seeing
It is correct that a current return path is needed, especially for AC coupled signals. The CN0359 does not use AC-coupling on the signal. The current driving the conductivity probe enters through one of the electrodes (the one connected to pin 1 of J5 and/or pin 2 if it is a 2-electrode probe) and has its return path via the trans-impedance amplifier U19.
Nikko-I am attaching pics of the scope shots.
The first one is a time lapse showing the gradual drift of the overall signal. The other shots are of pins 1,2,and 3 w.r.t ground.
Glenn-we had replaced the failed probe some time ago and are running 2 or 3 of you boards with fresh probes, all exhibiting the same behaviour. We also have run the CN0359 with a commercial TOPAC probe and it similarly shows this problem.
I do not quite understand how the system can work with the common mode drifting between the rails and indeed when it does this an error condition is raised by your software.
Where are you located? We can send you a few test probes.
Meanwhile have you tested this with a probe of your own and watched the voltages with a o'scope? If you see the problem you can continue analyzing it. If not we can buy the same probe and do some tests with it here.
Also is it possible to communicate via telephone? We lose a whole day between each exchange otherwise and we can quickly try the things that you suggest over the phone.
Do you want the test probes?
We would be happy to take a look at your application.
If you could send us a sample of your probe. We are located in our office here in the Philippines. Our address is below:
Analog Devices Inc.
Gateway Business Park
Javalera Gen. Trias, Cavite
Postal Code 4107
Attention to: Glenn Amparo
Thanks Glenn-I shipped out two sensors today and I would expect them to arrive late in the week.
Keep in mind that we see this same problem with 4-pole sensors from other vendors so if you have one on hand you may get started with that.
Thank you for sending the probes. We look forward to its arrival.